First, clean code: Press the remote control button for about one second after the above two LED lights flash, indicating that the code has been cleared. Then press any key, LED lights momentarily once the code has been cleared of Delegates success. Second, copy: after the wife and as close as possible from the remote copy remote control, hold down the first wife of a remote control button until the indicator light then immediately press and hold a copy of the remote control button for about one second, the red LED flashes quickly , indicating that this key address code has been learning success on the remote control to operate other three keys are the same way. If you normally use after accidentally accidentally cleared the remote control address code has been properly used, can hold down the button on the remote control following two keys for about 3 seconds, LED light begins flashing rapidly: three, restored after misuse release, is cleared to successfully address code recovery. Note: Due to the remote control transmitter signal has angle of the points, in case the remote copy in the copy process does not light or flash, indicating that signal reception is poor, then the need to copy the original remote control remote control next four try to copy a corner. 

keywords: Copy remote control,